 |
Click flag to download the Power-Lift Brochure |
|
|
Single Scissor
|
-
More than 40 different types
-
Stroke approx. 0.62 x platform length
|
| 1 |
Flat
or tear pattern deck top, The top roll over edges are
square (not radius) for greater strength, smoother load
transfer and flush mounting of handrail, conveyors etc. |
|
| 2 |
A perimeter
safety trip frame is fitted to the undersides of the
platform to prevent further lowering should an obstruction
be encountered. For added safety, operator reset is
standard. |
|
| 3 |
The scissor
arms for lift tables upto 3 metres in length are usually
profiled, solid steel. For larger lifts, steel hollow
section is used to provide greater stability. A substantial
torsion tube is fitted between the armsets to help ensure
good synchronisation and stability even when eccentrically
loaded. |
|
| 4 |
Bearing
Bushes |
notes |
| 5 |
The 1.400
rpm power packs are selected for their exceptional reliability
and low noise (<70dBA). A built in high pressure
filter helps protect the lowering valve from malfunction.
The lowering speed is adjustable on site and is controlled
by a pressure compensating valve. Mains supply 400V,
3 phase, 50Hz; control circuits 24V, 50 Hz. except for
types marked *(230V, 1 phase, 50Hz), Each lift is protected
to IP54 and is ready to use when connected to a mains
supply and suitably installed. The control station is
on 3 metres of flexible cable complete with Emergency
Stop and deadman (constant pressure) UP and DOWN push
buttons. |
|
| 6 |
Steel
swivel stops or posts are provided to mechanically support
the lift in a raised or semi-raised position to allow
access for maintenance purposes. |
|
| 7 |
The steel
arm roller bearings are replaceable. |
|
| 8 |
Cylinder
Tubes |
notes |
|
|
|
5 tonnes U.D.L
4000 mm long x 1500 mm wide
2500 mm stroke.
|
4 tonnes U.D.L
For feeding steel sheet in machine shop
VW works.
|
|
